Holley terminator X Coyote Engines

erminator X and X Max Features and Benefits
Plug and play 5.0L Coyote engine control
Ford Drive-by Wire Throttle Body Control (Terminator X Max Only)
4R70W Transmission Control (Terminator X Max Only)
Genuine Bosch LSU 4.9 Wideband Control (Will not work with LSU 4.2 Oxygen Sensors)
On-Board Diagnostic LEDS for: ECU Power – Engine Run – Wideband Status – TPS Calibration – Crank Signal – Cam Signal. Allow you to identify any Critical engine issues at a glance
Built in 1bar MAP Sensor, vacuum hose adapters included (1/8th – ¼ and 3/16ths) - or for Boosted applications, you can disable the internal MAP sensor, and utilize an external MAP Sensor, the harness comes with the connector terminated, making the installation a snap.
4 Inputs – 12v, Ground, 5v, and Frequency, for things such as additional pressure sensors, or activation triggers for nitrous activation, or a trans brake (Fuel and Oil Pressure Inputs are pre-terminated)
4 Outputs – Ground, PWM - , for accessories such as; fans, boost control, nitrous control, IAC Kit, and More
Boost Control – Boost vs Time, Boost vs Gear, Boost vs RPM, Boost vs Speed, Boost Safeties
Nitrous Control – Single Channel of Wet or Dry, Progressive or Non-Progressive, Rich/Lean Safeties, and target Closed Loop AFR
Advanced Tables – 4x 1D Tables, 1x 1D per Gear Table, 4x 2D Tables, 1x 2D per Gear Table
Integrated Datalogging to the 3.5” Handheld SD Card
Free EFI Tuning Software for complete control of your Terminator X power plant

For more information, please visit this product's webpage.


Contact Southeast Performance

  • +1(813)886-6166
  • +1(813)503-8069
  • Tampa, FL 33607
  • Email Us

Copyright © 2024 South East RT - Built by PRO-Webs.net